Jaguar X-Type Sedan and Estate (Wagon). Manual

Published: 11-May-2011

Horn - Horn Switch

Removal and Installation

Removal

1. Remove the driver air bag module.

For additional information, refer to:

Driver Air Bag Module

(501-20B

Supplemental Restraint System, Removal and Installation).

2. Disconnect the horn switch electrical connector.

3. Remove the horn switch.

Remove the horn switch retaining screws.

Installation

1. To install, reverse the removal procedure.

Published: 11-May-2011

Information and Message Center - Information and Message Center

Description and Operation

Item

Part Number

Description

—

Instrument Cluster

—

Red Warning Lamp

—

Amber W arning Lamp

—

Driver's Information/Message Center

The driver's information/message center has a dot matrix

LCD (liquid crystal display)

and is located in the lower area of the speedometer.

The message center displays messages in text form for the driver, including odometer readings and trip computer data. It can also provide
information normally covered by conventional warning lamps or typically indicate that a feature such as the cruise control is operating.

Located above the message center are two lamps, red for warning and amber for caution. W hen a message is displayed, the appropriate
lamp will illuminate to attract the driver's attention and to signify the importance of the message.

On 2.2L Diesel vehicles from 2009MY using the AW F21 transmission, when 'Sport' mode is selected using the selector lever, 'S' is displayed
and when in Jaguar Sequential Shift mode the selected gear (1, 2, 3, 4, 5, or 6) is displayed.

Trip Computer

The trip computer can be accessed by pressing the trip computer button located on the end of the

LH (left-hand)

steering column

multifunction switch. Pressing the trip button displays trip data on the message center. Warning and information messages have priority
over trip data. If a driver information message is displayed prior to activation of the trip computer, the trip data will appear for 10 seconds
only, before being replaced by the original message.

Each successive press of the trip button causes the computer to continually cycle through the stored data which is then displayed on the
message center.

The trip computer button is only enabled while the trip computer output is displayed. Refer to the Drivers Handbook for full operating
instructions.

Service Interval Indicator - Vehicles with Diesel Particulate Filter (DPF)

The Service Interval Indicator informs the driver that the engine requires an engine oil change due to excessive build-up of fuel within the
engine oil. This is due to the Diesel Particulate Filter (DPF) regeneration process where additional fuel quantities are added to increase
exhaust gas temperatures. As a result small quantities of unburnt fuel remain in the combustion chamber and bypass the piston rings into
the engine oil.

The amount of excessive fuel is calculated by the

ECM (engine control module)

. The

ECM

monitors the engine operating conditions and the

values from the exhaust gas temperature sensor during the DPF regeneration process and calculates the amount of fuel in the oil. If the fuel
content exceeds the permitted level, the

ECM

will illuminate the service interval indicator in the instrument cluster message center.

After the engine oil has been changed, a service indicator reset procedure must be carried out.
For additional information, refer to:

Oil Change Indicator Reset

(413-09 Warning Devices, General Procedures).

Published: 11-May-2011

Information and Message Center - Information and Message Center

Diagnosis and Testing

Inspection and Verification

1. Verify the customer concern.

2. Visually inspect for obvious signs of electrical damage.

Visual Inspection Chart

Electrical

Fuse(s)

Electrical connector(s)

Damaged or corroded wiring harness

Engine/engine compartment or underbody components

Instrument cluster

3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next

step.

4. If the cause is not visually evident, verify the symptom and refer to the Jaguar Approved Diagnostic System.

Jaguar X-Type Sedan and Estate (Wagon). Manual - part 514