Jaguar X-Type Sedan and Estate (Wagon). Manual - part 25
Published: 11-May-2011
Suspension System - General Information - Rear Toe Adjustment
General Procedures
• NOTE: The checking and subsequent adjustment of the rear toe setting should be carried out on a flat surface and in accordance with the
manufactures instructions for the wheel alignment equipment used.
1. NOTE: Final tightening of the rear suspension components should be
carried out when the vehicle weight is on the road wheels.
Using suitable four wheel alignment equipment, check the toe setting.
2. Raise and support the vehicle.
For additional information, refer to Section
100-02 Jacking and Lifting
.
3. NOTE: Left-hand shown, right-hand similar.
Loosen the rear lower arm cam bolt nuts.
4. Rotate the the cam bolts equal amounts, in either a clockwise or a
counterclockwise direction, to adjust the toe setting.
5.
CAUTION: The final tightening of the suspension components
should be carried out with the vehicle on its wheels. Failure to follow this
instruction may result in damage to the vehicle.
• NOTE: Left-hand shown, right-hand similar.
Tighten the rear lower arm cam bolt nuts.
6. Lower the vehicle.
Bounce the vehicle to make sure that the suspension is in its
normal resting position.