|
|
Mass Air Flow (MAF) Sensor (18.30.15) Removal
1 . Remove the mass airflow (MAF) sensor.
1) Disconnect the MAF sensor electrical connector.
2) Remove the mass airflow MAF sensor.
Remove and discard the MAF sensor O-ring seal.
Installation
1 . To install, reverse the removal procedure.
Install a new MAF sensor O-ring seal.
2 .
NOTE:
For NAS vehicles only.
If required, carry out a short drive cycle. For additional information, refer to Powertrain Control Module (PCM) Short Drive Cycle Self- Test
|