|
|
EM-156 < PRECAUTION > [VK50VE] PRECAUTIONS If turning the steering wheel is required with the battery disconnected or discharged, follow the operation pro- OPERATION PROCEDURE 1. Connect both battery cables. 2. Turn the push-button ignition switch to ACC position. 3. Disconnect both battery cables. The steering lock will remain released with both battery cables discon- 4. Perform the necessary repair operation. 5. When the repair work is completed, re-connect both battery cables. With the brake pedal released, turn 6. Perform self-diagnosis check of all control units using CONSULT-III. Precaution for Drain Engine Coolant and Engine Oil INFOID:0000000005245198 Drain engine coolant and engine oil when engine is cooled. Precaution for Disconnecting Fuel Piping INFOID:0000000005245199 • Before starting work, check no fire or spark producing items are in the work area. Precaution for Removal and Disassembly INFOID:0000000005245200 • When instructed to use SST, use specified tools. Always be careful to work safely, avoid forceful or unin- structed operations. • Exercise maximum care to avoid damage to mating or sliding surfaces. opposite, and so on. If the order of loosening is specified, do exactly as specified. Power tools may be used Precaution for Inspection, Repair and Replacement INFOID:0000000005245201 Before repairing or replacing, thoroughly inspect parts. Inspect new replacement parts in the same way, and Precaution for Assembly and Installation INFOID:0000000005245202 • Use torque wrench to tighten bolts or nuts to specification. ones in center, then ones on inside and outside diagonally in this order. If the order of tightening is specified, • Replace with new gasket, packing, oil seal or O-ring. any restriction and blockage. • Dowel pins are used for several parts alignment. When replacing and reassembling parts with dowel pins, check that dowel pins are installed in the original position. • Avoid damaging sliding or mating surfaces. Completely remove foreign materials such as cloth lint or dust. Before assembly, oil sliding surfaces well. • Release air within route when refilling after draining engine coolant. exhaust gases for leakage. |