|
|
DRIVE PINION DLN-251 < UNIT DISASSEMBLY AND ASSEMBLY > [REAR FINAL DRIVE: R200] C E F G H I J K L M A B DLN N O P 12. Install differential case assembly. Refer to . CAUTION: Never install rear cover at this timing. 13. Check and adjust drive gear runout, tooth contact, drive gear to drive pinion backlash, and companion flange runout. Refer to . Recheck above items. Readjust the above description, if necessary. 14. Check total preload torque. Refer to . 15. Install rear cover. Refer to AWD : Adjustment INFOID:0000000005249255 PINION GEAR HEIGHT 1. Make sure all parts are clean and that the bearings are well 2. Assemble the pinion gear bearings into the differential shim — (J-34309)]. • Pinion front bearing; make sure the J-34309-3 pinion front bearing seat is secured tightly against the J-34309-2 gauge • Pinion rear bearing; the pinion rear bearing pilot, J-34309-8, is used to center the pinion rear bearing only. The pinion rear • Installation of J-34309-9 and J-34309-16; place a suitable 2.5 mm (0.098 in) thick plain washer between J-34309-9 and 3. Install the pinion rear bearing inner race into gear carrier. Then SPD769 SPD197A SPD893 |