|
|
DRIVE PINION DLN-243 < UNIT DISASSEMBLY AND ASSEMBLY > [REAR FINAL DRIVE: R200] C E F G H I J K L M A B DLN N O P • Pinion front bearing; make sure the J-34309-3 pinion front bearing seat is secured tightly against the J-34309-2 gauge • Pinion rear bearing; the pinion rear bearing pilot, J-34309-8, is used to center the pinion rear bearing only. The pinion rear • Installation of J-34309-9 and J-34309-16; place a suitable 2.5 mm (0.098 in) thick plain washer between J-34309-9 and 3. Install the pinion rear bearing inner race into gear carrier. Then 4. Assemble the pinion front bearing inner race and the J-34309-2 5. Turn the assembly several times to seat the bearings. 6. Measure the turning torque at the end of the J-34309-2 gauge SPD197A SPD893 SPD199A SPD770 Standard Turning torque specifica- : 1.0 – 1.3 N·m (0.11 – 0.13 PDIA0566E |