|
|
Content .. 1191 1192 1193 1194 ..
PWC-36 < COMPONENT DIAGNOSIS > POWER WINDOW SERIAL LINK 2. CHECK BCM OUTPUT SIGNAL Check power window serial link (“PW REMOTO DOWN SET”) in “ACTIVE TEST” mode with CONSULT-III. Is the inspection result normal? YES >> GO TO 4. NO >> Replace BCM. Refer to BCS-84, "Removal and Installation" 3. CHECK POWER WINDOW SERIAL LINK CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect BCM connector. 3. Disconnect power window main switch connector and front power window switch (passenger side) con- 4. Check continuity between BCM connector and power window main switch connector. 5. Check continuity between BCM connector and ground. Is the inspection result normal? YES >> Replace BCM. Refer to BCS-84, "Removal and Installation" NO >> Repair or replace harness. 4. CHECK INTERMITTENT INCIDENT GI-38, "Intermittent Incident" >> INSPECTION END Test item Description POWER WINDOW DOWN ON Driver side window and passenger side window OPEN BCM Power window switch Continuity Connector Terminal Connector Terminal M123 132 Driver side D8 14 Existed Passenger side D38 16 BCM Ground Continuity Connector Terminal M123 132 Not existed |