Content   ..  12  13  14  15   ..

Hyundai Grand Santa Fe (2016 year). Instruction - part 14

Features of your vehicle

Windshield wipers

Auto control (if equipped)

CAUTION

Operates as follows when the igni-

When the ignition switch is ON

tion switch is turned ON.

and the windshield wiper switch

/ MIST : For a single wiping cycle,

is placed in the AUTO mode, use

move the lever to this

caution in the following situa-

(

/ MIST) position and

tions to avoid any injury to the

release it. The wipers will

hands or other parts of the body:

operate continuously if

•

Do not touch the upper end of

the lever is held in this

the windshield glass facing

position.

the rain sensor.

O / OFF : Wiper is not in operation

Rain sensor

•

Do not wipe the upper end of

--- / INT : Wiper operates intermittently

the windshield glass with a

ODMECO2022

at the same wiping intervals.

damp or wet cloth.

Use this mode in light rain or

The rain sensor located on the upper

•

Do not put pressure on the

mist. To vary the speed setting,

end of the windshield glass senses

windshield glass.

turn the speed control knob.

the amount of rainfall and controls

the wiping cycle for the proper inter-

1 / LO : Normal wiper speed

val. The more it rains, the faster the

2 / HI : Fast wiper speed

wiper operates.

When the rain stops, the wiper stops.

✽ NOTICE

To vary the speed setting, turn the

If there is heavy accumulation of

speed control knob (1).

snow or ice on the windshield, defrost

If the wiper switch is set in AUTO

the windshield for about 10 minutes,

mode when the ignition switch is ON,

or until the snow and/or ice is

the wiper will operate once to per-

removed before using the windshield

form a self-check of the system. Set

wipers to ensure proper operation.

the wiper to OFF position when the

wiper is not in use.

4 137

Features of your vehicle

Windshield washers

Use this function when the wind-

CAUTION

shield is dirty.

(if equipped)

When washing the vehicle, set

The spray and wiper operation will

■ Type A

the wiper switch in the OFF

continue until you release the lever.

position to stop the auto wiper

If the washer does not work, check

operation.

the washer fluid level. If the fluid level

The wiper may operate and be

is not sufficient, you will need to add

damaged if the switch is set in

appropriate non-abrasive windshield

the AUTO mode while washing

washer fluid to the washer reservoir.

the vehicle.

The reservoir filler neck is located in

Do not remove the sensor cover

the front of the engine compartment

located on the upper end of the

on the passenger side.

passenger side windshield

ODMECO2021

■ Type B

glass. Damage to system parts

could occur and may not be cov-

ered by your vehicle warranty.

When starting the vehicle in

winter, set the wiper switch in

the OFF position. Otherwise,

wipers may operate and ice may

damage the windshield wiper

blades. Always remove all snow

and ice and defrost the wind-

ODM042257

shield properly prior to operat-

ing the windshield wipers.

In the OFF position, pull the lever

gently toward you to spray washer

fluid on the windshield and to run the

wipers 1-3 cycles.

4 138

Features of your vehicle

Headlight washer (if equipped)

CAUTION

CAUTION

If your vehicle is equipped with the

To prevent possible damage to

•

To prevent possible damage

headlight washer it will operate at the

the washer pump, do not oper-

to the wipers or windshield,

same time when you operate the

ate the washer when the fluid

do not operate the wipers

windshield washer. It will operate

reservoir is empty.

when the windshield is dry.

when the headlight low beam is

•

To prevent damage to the wiper

turned on and the ignition switch or

blades, do not use gasoline,

engine start/stop button is in the ON

WARNING

kerosene, paint thinner, or

position.

other solvents on or near them.

The washer fluid will be sprayed on

Do not use the washer in freez-

ing temperatures without first

•

To prevent damage to the

to the headlights.

warming the windshield with

wiper arms and other compo-

the defrosters; the washer solu-

nents, do not attempt to move

✽ NOTICE

tion could freeze on the wind-

the wipers manually.

• Check the headlight washers peri-

shield and obscure your vision.

odically to confirm that the wash-

er fluid is being sprayed properly

onto the headlight lenses.

• The headlight washer can be oper-

ated 15 minutes after being oper-

ated last time.

4 139

Features of your vehicle

Rear window wiper and wash-

HI / 2 - High wiper speed

■ Type A

er switch (if equipped)

LO / 1- Low wiper speed

■ Type A

OFF / O - Off

ODMECO2024

■ Type B

ODMECO2023

■ Type B

ODM042338

Push the lever away from you to

spray rear washer fluid and to run the

ODM042256

rear wipers

1~3 cycles. The spray

The rear window wiper and washer

and wiper operation will continue until

switch is located at the end of the

you release the lever. (if equipped)

wiper and washer switch lever. Turn

the switch to the desired position to

operate the rear wiper and washer.

4 140

Features of your vehicle

INTERIOR LIGHT

Interior lamp AUTO cut

Map lamp

CAUTION

• When all entrances are closed, if

■ Type A

Do not use the interior lights for

you lock the vehicle by using the

extended periods when the

transmitter or the smart key, all

engine is not running.

interior lamp will be off within

5

It may cause battery discharge.

seconds.

• If you do not operate anything in

the vehicle after turning off the

WARNING

engine, the lights will turn off after

20 minutes.

Do not use the interior lights

ODM042258

when driving in the dark.

■ Type B

Accidents

could

happen

because the view may be

obscured by interior lights.

ODM042259

■ Type C

ONCDCO3048

4 141

Features of your vehicle

Room lamp

Vanity mirror lamp

Luggage room lamp

■ Type A

ODM042260

■ Type B

OEN046081

OXM049136

Opening the cover of the vanity mir-

• ON : The luggage room lamp stays

ror will automatically turn on the mir-

on at all times.

ror lamp.

• DOOR : The luggage room lamp

comes on when the tail-

gate is opened.

• OFF : The luggage room lamp is off.

ODM042341

Press the button to turn the light on

or off.

4 143

Features of your vehicle

Glove box lamp

Door courtesy lamp

(if equipped)

ODM042262

ODM042261

The glove box lamp comes on when

the light switch is in the parking light

The door courtesy lamp comes ON

position or headlight position and the

when the door is opened to assist

glove box is opened.

entering or exiting the vehicle. It also

serves as a warning to passing vehi-

cles that the vehicle door is open.

4 144

Features of your vehicle

DEFROSTER

Rear window defroster

• To activate the rear window

CAUTION

defroster, press the rear window

■ Manual climate control

To prevent damage to the con-

defroster button located in the cen-

ductors bonded to the inside

ter facia switch panel. The indicator

surface of the rear window,

on the rear window defroster but-

never use sharp instruments or

ton illuminates when the defroster

window cleaners containing

is ON.

abrasives to clean the window.

• To turn off the defroster, press the

rear window defroster button again.

✽ NOTICE

✽ NOTICE

If you want to defrost and defog the

ODM042271

• If there is heavy accumulation of

front

windshield,

refer

to

■ Automatic climate control

snow on the rear window, brush it

“Windshield

Defrosting

and

off before operating the rear

Defogging” in this section.

defroster.

• The rear window defroster auto-

matically turns off after approxi-

mately 20 minutes or when the

ignition switch is turned off.

ODM042272/Q

The defroster heats the window to

remove frost, fog and thin ice from

the interior and exterior of the rear

window, while engine is running.

4 146

Features of your vehicle

MANUAL CLIMATE CONTROL SYSTEM (IF EQUIPPED)

■ Front climate control (Type A)

■ Front climate control (Type B)

1. Front windshield defrost button

2. Temperature control button

3. Air conditioning button

4. MAX A/C (Max airconditioning) button

5. Rear window defroster button

6. Air intake control button

7. Mode selection button

8. Fan speed control knob

9. 3rd row climate control ON/OFF

button

■ 3rd row air climate control (for Type A)

10. 3rd row fan speed control knob

11. 3rd row blower ON/OFF button

12. 3rd row mode selection button

13. 3rd row temperature control knob*

* if equipped

ONCNCL2001/ODM042273/ONCNCL2002

4 148

Features of your vehicle

Heating and air conditioning

1.Start the engine.

2.Set the mode to the desired posi-

tion.

For improving the effectiveness of

heating and cooling;

- Heating:

- Cooling:

3.Set the temperature control to the

desired position.

4.Set the air intake control to the out-

side (fresh) air position.

5.Set the fan speed control to the

desired speed.

6.If air conditioning is desired, turn

the air conditioning system

(if

equipped) on.

ONCNCL2003

❈ 2nd and 3rd row outlet vents (E, F, G, H) (Vent G, H : if equipped)

• The air flow of the 2nd and 3rd row outlet vents is controlled by the front cli-

mate control system and delivered through the inside air duct of the floor

(E, F).

• The air flow of the 2nd and 3rd row outlet vents (E, F) may be weaker than

the instrument panel vents for the long air duct.

• Close the air vents (F) in cold weather. The air flow of the 2nd and 3rd row

outlet vents may cool a little during heating operation. (Use the 2nd and 3rd

row outlet vents (F, G) during cooling operation.)

4

149

Features of your vehicle

Mode selection

Floor/Defrost-Level

Face-Level (B, D, F)

(A, C, D, E)

Most of the air flow is directed to the

Air flow is directed toward the upper

body and face. Additionally, each

floor and the windshield with a small

amount directed to the side window

outlet can be controlled to direct the

air discharged from the outlet.

defrosters.

Bi-Level (B, C, D, E, F)

Defrost-Level (A, D)

ODMECL2002

Most of the air flow is directed to the

Air flow is directed towards the face

The mode buttons control the direc-

windshield with a small amount of air

and the floor.

tion of the air flow through the venti-

directed to the side window defrosters.

lation system.

Air can be directed to the floor, dash-

board outlets, or windshield. Five

Floor-Level (A, C, D, E)

symbols are used to represent Face,

Bi-Level, Floor, Floor-Defrost and

Most of the air flow is directed to the

Defrost air position.

floor, with a small amount of the air

being directed to the windshield and

side window defrosters.

4 150

Features of your vehicle

Temperature control

ODM042277

ODM042279

MAX A/C-Level (if equipped)

Instrument panel vents

ODM042280

To select the MAX A/C, turn the fan

The outlet vents can be opened or

The temperature control switch

speed control knob to the right then

closed separately using the thumb-

allows you to control the temperature

press the MAX A/C button.

wheel.

of the airflow in the vehicle.

Air flow is directed toward the upper

Also, you can adjust the direction of

To change the temperature:

body and face.

air delivery from these vents using

• Press the

(red) switch to

the vent control lever as shown.

In this mode, the air conditioning and

increase temperature.

the recirculated air position will be

• Press the

(blue) switch to

selected automatically.

decrease temperature.

The temperature status will be dis-

played at the above switch panel as

a indicator.

4 151

Features of your vehicle

Air intake control

Type A

Type B

Recirculated air position

Recirculated air position

■ Type A

With the recirculated air

With the recirculated air

position selected, air

position selected, air

from the passenger

from the passenger

compartment will be

compartment will be

drawn through the heat-

drawn through the heat-

ing system and heated

ing system and heated

or cooled according to

or cooled according to

the function selected.

the function selected.

ONCNCL2004

Outside (fresh) air position

Outside (fresh) air position

■ Type B

With the outside (fresh)

With the outside (fresh)

air position selected, air

air position selected, air

enters the vehicle from

enters the vehicle from

outside and is heated or

outside and is heated or

cooled according to the

cooled according to the

function selected.

function selected.

ODM042281

The air intake control is used to

select the outside (fresh) air position

or recirculated air position.

To change the air intake control posi-

tion, press the control button.

4 152

Features of your vehicle

✽ NOTICE

Fan speed control

Prolonged operation of the heater in

WARNING

the recirculated air position (with-

•

Continue using the climate

out air conditioning selected) may

control system in the recircu-

cause fogging of the windshield and

lated air position may allow

side windows and the air within the

humidity to increase inside

passenger compartment may

the vehicle which may fog the

become stale.

glass and obscure visibility.

In addition, prolonged use of the air

•

Do not sleep in a vehicle with

conditioning with the recirculated

the air conditioning or heating

air position selected will result in

system on. It may cause seri-

excessively dry air in the passenger

ous harm or death due to a

compartment.

drop in the oxygen level

ODM042282

and/or body temperature.

The ignition switch must be in the ON

•

Continue using the climate

position for fan operation.

control system in the recircu-

lated air position can cause

The fan speed control knob allows

you to control the fan speed of the air

drowsiness or sleepiness, and

loss of vehicle control. Set the

flowing from the ventilation system.

To change the fan speed, turn the

air intake control to the outside

(fresh) air position as much as

knob to the right for higher speed or

left for lower speed.

possible while driving.

Setting the fan speed control knob to

the “0” position turns off the fan.

4 153

Content   ..  12  13  14  15   ..