|
|
Clutch CL-7 When install the clutch pressure plate and driven disc, insert the spe- cial tool into the clutch driven disc spline (used to align and orient). Screw down the fixing bolt of the clutch cover. Screw down the bolt in an crossed sequence, following two steps. 1.Installation and adjustment Check the type of the clutch to make sure if it is accord to the vehicle model before installation, then find out if the size of installation screw During the installation, first insert the locating mandrel into the spline hole of the driven disc and set it on the flywheel end. Then install When adjust the control mechanism, you have to make sure that the travel of the release bearing is 2~3mm, and the efficient travel of the 2.Notice Pay attention to match the proper torque of the engine during using, which is to assure the certain repertory coefficient. The friction plate mustn't be contaminated with oil stain during using. The vehicle should not be over loaded during using to avoid skid and cause wear. Never make the driven disc in a half engaging situation during using to avoid too much wear earlier. 3.Maintenance If the driven disc has been a little bit worn, you must adjust the con- trol mechanism periodically to assure the proper free travel. When the friction plate is worn too much like the distance between its surface to the rivet head is not more than 0.5mm, you have to change a When maintaining the engine, you must clean up the surrounding place of the inner support disc and ring of the cover assembly. If you need to disassemble the pressure plate to do the clean, do remember to assemble it to its original place to assure its balance. |