|
|
• When Monitored: • With the Highbeam Headlamps activated. • Set Condition: • When the FCM detects a High condition. Possible Causes (L34) RIGHT HIGHBEAM OUTPUT CIRCUIT FRONT CONTROL MODULE Diagnostic Test 1. INTERMITTENT CONDITION Turn the ignition on. With the Scan Tool, clear all FCM DTC’s. Turn the Highbeam Headlamps on. With the Scan Tool read the DTC information. Does the Scan Tool read: B1637-RIGHT HI BEAM CONTROL CIRCUIT LOW? Yes >> Go To 2 No >> The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires. Perform the BODY VERIFICATION TEST - VER 1. 2. (L34) RIGHT HIGHBEAM OUTPUT CIRCUIT Turn the ignition off. Disconnect the FCM C2 harness connector. Measure the resistance between ground and the (L34) Right Highbeam Is the resistance below 5.0 ohms? Yes >> Replace the Front Control Module (FCM) in accordance with the service information. Perform the BODY VERIFICATION TEST - VER 1. No >> Repair the (L34) Right Highbeam Output circuit for a short to ground condition. Perform the BODY VERIFICATION TEST - VER 1. 8L - 14 LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS LX |