|
|
3. Disconnect wiring harness (1) connector at sensor (3). 4. Remove nuts (2) mounting sensor (3) to floor pan tunnel (4). 5. Remove dynamics sensor (3) from vehicle. INSTALLATION 1. Install dynamics sensor (3) over studs mounted to floor pan tunnel (4). 2. Install mounting nuts (2). Tighten nuts to 12 N·m (110 in. lbs.) torque. 3. Connect wiring harness (1) connector to module (3). 4. Install floor console. (Refer to 23 - BODY/INTERI- OR/FLOOR CONSOLE - INSTALLATION) 5 - 394 BRAKES - ABS SERVICE INFORMATION LX |