Chrysler 300/300 Touring/300C, Dodge Magnum. Manual - part 2298

 

  Index      Chrysler     Chrysler 300/300 Touring/300C, Dodge Magnum - service repair manual

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  2296  2297  2298  2299   ..

 

 

Chrysler 300/300 Touring/300C, Dodge Magnum. Manual - part 2298

 

 

3.

CHECK THE RECIRCULATION DOOR & A/C HEATER HOUSING FOR WARPED, WORN, DAMAGED,
MISSING, & BROKEN COMPONENTS

Inspect for excessively worn, disconnected, missing, or broken door linkage. Inspect for a damaged or broken A/C
Heater Housing Assembly. Inspect for a warped or broken door, and missing door seals. Rotate the door from stop
to stop. The door should rotate approximately 100 degrees.

Are there any physical or mechanical problems with the door or housing?

Yes

>> Repair as necessary in accordance with the Service Information.

Perform BODY VERIFICATION TEST – VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/FRONT CONTROL MODULE - DIAGNOSIS AND TESTING).

No

>> Replace the Recirculation Door Actuator in accordance with the Service Information. Then, Go To 4.

4.

RUN THE ACTUATOR CALIBRATION TEST

Turn the ignition on.

With the scan tool, select System Tests and then select Actuator Calibration Test. When the test is complete, select
View DTCs.

Does the scan tool display: B105D–RECIRCULATION DOOR TRAVEL RANGE TOO LARGE?

Yes

>> Replace the A/C Heater Control in accordance with the Service Information.

Perform BODY VERIFICATION TEST – VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/FRONT CONTROL MODULE - DIAGNOSIS AND TESTING).

No

>> Perform BODY VERIFICATION TEST – VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL

MODULES/FRONT CONTROL MODULE - DIAGNOSIS AND TESTING).

24 - 226

HVAC - ELECTRICAL DIAGNOSTICS

LX

B106B–REAR DEFROST CONTROL CIRCUIT LOW (ATC)

For a complete wiring diagram Refer to Section 8W.

LX

HVAC - ELECTRICAL DIAGNOSTICS

24 - 227

When Monitored:
With ignition on.

Set Condition:
If the EBL output is turned off and the (C115) Rear Window Defogger Relay Control circuit is either shorted to
ground or open.

Possible Causes

(C115) REAR WINDOW DEFOGGER RELAY CONTROL CIRCUIT SHORTED TO GROUND

(C115) REAR WINDOW DEFOGGER RELAY CONTROL CIRCUIT OPEN

REAR WINDOW DEFOGGER RELAY

A/C HEATER CONTROL

NOTE: This DTC must be active for the results of this test to be valid. Do not perform this test if this DTC
is stored. Refer to HVAC System Test (ATC) for stored DTC test procedures.

Diagnostic Test

1.

INSTALL A SUBSTITUTE REAR WINDOW DEFOGGER RELAY & THEN CHECK FOR DTC B106B–REAR
DEFROST CONTROL CIRCUIT LOW

Turn the ignition on.

Verify that the EBL mode switch is off.

Turn the ignition off.

Install a substitute Rear Window Defogger Relay.

Turn the ignition on.

With the scan tool, erase HVAC DTCs.

Turn the ignition off, wait 10 seconds, and turn the ignition on.

With the scan tool, read HVAC DTCs.

Does the scan tool display: B106B–REAR DEFROST CONTROL
CIRCUIT LOW?

Yes

>> Go To 2

No

>> Replace the original Rear Window Defogger Relay in accor-

dance with the Service Information.

Perform BODY VERIFICATION TEST – VER 1. (Refer to 8
-

ELECTRICAL/ELECTRONIC

CONTROL

MODULES/

FRONT CONTROL MODULE - DIAGNOSIS AND TEST-
ING).

24 - 228

HVAC - ELECTRICAL DIAGNOSTICS

LX

2.

CHECK (C115) REAR WINDOW DEFOGGER RELAY CONTROL CIRCUIT FOR A SHORT TO GROUND

Turn the ignition off.

Remove the substitute Rear Window Defogger Relay.

Disconnect the A/C Heater Control C1 harness connector.

Measure the resistance of the (C115) Rear Window Defogger Relay
Control circuit between ground and the A/C Heater Control C1 harness
connector.

Is the resistance below 10k ohms?

Yes

>> Repair the (C115) Rear Window Defogger Relay Control

circuit for a short to ground. Reinstall the original Rear Win-
dow Defogger Relay.

Perform BODY VERIFICATION TEST – VER 1. (Refer to 8
-

ELECTRICAL/ELECTRONIC

CONTROL

MODULES/

FRONT CONTROL MODULE - DIAGNOSIS AND TEST-
ING).

No

>> Go To 3

3.

CHECK (C115) REAR WINDOW DEFOGGER RELAY CONTROL CIRCUIT FOR AN OPEN

Measure the resistance of the (C115) Rear Window Defogger Relay
Control circuit between the Rear Window Defogger Relay connector ter-
minal 85 in the PDC and the A/C Heater Control C1 harness connector.

Is the resistance below 5.0 ohms?

Yes

>> Replace the A/C Heater Control in accordance with the Ser-

vice Information. Reinstall the original Rear Window Defog-
ger Relay.

Perform BODY VERIFICATION TEST – VER 1. (Refer to 8
-

ELECTRICAL/ELECTRONIC

CONTROL

MODULES/

FRONT CONTROL MODULE - DIAGNOSIS AND TEST-
ING).

No

>> Repair the (C115) Rear Window Defogger Relay Control

circuit for an open. Reinstall the original Rear Window
Defogger Relay.

Perform BODY VERIFICATION TEST – VER 1. (Refer to 8
-

ELECTRICAL/ELECTRONIC

CONTROL

MODULES/

FRONT CONTROL MODULE - DIAGNOSIS AND TEST-
ING).

LX

HVAC - ELECTRICAL DIAGNOSTICS

24 - 229

 

 

 

 

 

 

 

Content   ..  2296  2297  2298  2299   ..