|
|
Content .. 1073 1074 1075 1076 ..
- Internal engine component failures. Were any of the above conditions present? Yes >> Repair as necessary. Perform the POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE) No >> Go To 3 3. (K343) ASD RELAY OUTPUT 2 CIRCUIT NOTE: On the 2.7 and 3.5L engines, cylinders 1, 3 and 5, it is nec- Disconnect the No.6 Ignition Coil harness connector. Disconnect the No.6 Fuel Injector harness connector. Ignition on, engine not running. With the scan tool, actuate the ASD Relay. Using a 12-volt test light connected to ground, probe the (K343) ASD Does the test light illuminate brightly? Yes >> Go To 4 No >> Repair the excessive resistance or short to ground in the (K343) ASD Relay Output 2 circuit. Perform the POWERTRAIN VERIFICATION TEST. (Refer 4. IGNITION SYSTEM OPERATION NOTE: On the 2.7 and 3.5L engines, cylinders 1, 3 and 5, it is necessary to remove the upper intake to Connect the Ignition Coil No.6 harness connector. Remove the Ignition Coil. 9 - 324 ENGINE ELECTRICAL DIAGNOSTICS LX |