|
|
Content .. 1023 1024 1025 1026 ..
6. (K41) O2 SENSOR 1/1 SIGNAL CIRCUIT SHORTED TO (K902) O2 RETURN UPSTREAM CIRCUIT Measure the resistance between the (K41) O2 Sensor 1/1 Signal circuit Is the resistance below 100 ohms? Yes >> Repair the short between the (K902) O2 Return Upstream circuit and the (K41) O2 Sensor 1/1 Signal circuit. Perform the POWERTRAIN VERIFICATION TEST. (Refer No >> Go To 7 7. (K41) O2 SENSOR 1/1 SIGNAL CIRCUIT SHORTED TO THE (Z904) O2 1/1 HEATER GROUND CIRCUIT Measure the resistance between the (K41) O2 Sensor 1/1 Signal circuit Is the resistance below 100 ohms? Yes >> Repair the short between the (Z904) O2 1/1 Heater ground circuit and the (K41) O2 Sensor 1/1 Signal circuit. Perform the POWERTRAIN VERIFICATION TEST. (Refer No >> Go To 8 8. PCM NOTE: Before continuing, check the PCM harness connector terminals for corrosion, damage, or terminal Were there any problems found? Yes >> Repair as necessary. Perform the POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE) No >> Replace and program the Powertrain Control Module per Service Information. Perform the POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE) 9 - 124 ENGINE ELECTRICAL DIAGNOSTICS LX |