|
|
Content .. 1012 1013 1014 1015 ..
• When Monitored: • Set Condition: Possible Causes (K2) ECT SIGNAL CIRCUIT SHORTED TO GROUND (K2) ECT SIGNAL CIRCUIT SHORTED TO THE (K900) SENSOR GROUND ECT SENSOR PCM Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 9 - ENGINE - Diagnostic Test 1. ECT SENSOR VOLTAGE BELOW 0.078 OF A VOLT Ignition on, engine not running. With a scan tool, read the ECT voltage. Is the voltage below 0.078 of a volt? Yes >> Go To 2 No >> Refer to the INTERMITTENT CONDITION Diagnostic Procedure. Perform the POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE) 2. ECT SENSOR Turn the ignition off. Disconnect the ECT harness connector. Ignition on, engine not running. With a scan tool, read ECT voltage. Is the voltage above 1.0 volt? Yes >> Replace the ECT Sensor. Perform the POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE) No >> Go To 3 9 - 80 ENGINE ELECTRICAL DIAGNOSTICS LX |