|
|
STANDARD PROCEDURE - FLUID DRAIN AND FILL NOTE: Note: The fluid required for use in this axle is Mopar T Synthetic Gear and Axle Lubricant 75W-140. 1. Drive the vehicle until the differential lubricant is at the normal operating temperature. 2. With vehicle in neutral, position and raise vehicle on hoist. 3. Remove rear axle drain plug and drain lubricant completely from the axle. 4. Install drain plug and tighten to 60 N·m (44 ft lbs). 5. Remove fill plug (1) and fill rear axle with 1.4 L (1.5 qts.) Mopar T Synthetic Gear & Axle Lubricant 75W- 140. 6. Install fill plug and tighten to 60 N·m (44 ft lbs). REMOVAL NOTE: This procedure requires the compression of the rear suspension to ride height. A drive-on hoist CAUTION: Never grasp halfshaft assembly by the inner or outer boots. Doing so may cause the boot to 3 - 112 REAR AXLE - 198RII LX |