|
|
Fig. 249: View Of EVAP Purge Solenoid Vent Tube 29. Remove the EVAP purge solenoid vent tube, perform the following: Remove the EVAP tube end (2) from the solenoid (1). Remove the EVAP tube end (3) from the vapor pipe. 30. Disconnect the fuel pipes. Refer to Metal Collar Quick Connect Fitting Service or Plastic Collar Quick Connect Fitting Service . 31. Raise the vehicle.
2008 Hummer H2 2008 ENGINE Engine Mechanical - 6.2L - H2
Fig. 250: Identifying Electrical Connector (Right Side Of Engine) 32. Disconnect the following electrical connectors: The crankshaft position (CKP) sensor (1) The engine oil level sensor (6) The coolant heater, if equipped
2008 Hummer H2 2008 ENGINE Engine Mechanical - 6.2L - H2
Fig. 251: View Of Positive Battery Cable, Channel & Bolt 33. Remove the battery cable channel bolt. 34. Slide the channel pin out of the oil pan tab.
2008 Hummer H2 2008 ENGINE Engine Mechanical - 6.2L - H2
|
|
|