|
|
Content .. 2336 2337 2338 2339 ..
BLOWER MOTOR REPLACEMENT Removal Procedure 1. If equipped, remove the sound insulator panel. Refer to Instrument Panel Insulator Replacement (with RPO SLT) or Instrument Panel Insulator Replacement (without 2. Remove the blower motor insulating cover screws. 3. Disconnect the electrical connector from the blower motor. 4. Remove the blower motor insulating cover. 1 Blower Motor Control Module Screw (Qty: 2) Tighten: 1.5 N.m (13 lb in) NOTE: Refer to Fastener Notice . 2 Blower Motor Control Module
2008 Chevrolet Silverado 1500 2008 HVAC Heating, Ventilation, and Air Conditioning - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 97: Disengaging Blower Motor (Delphi) 5. Pull the retaining tab down while turning the blower motor counterclockwise in order to disengage the blower motor from the heater/ventilation module.
2008 Chevrolet Silverado 1500 2008 HVAC Heating, Ventilation, and Air Conditioning - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 98: View Of Blower Motor (Delphi) 6. Remove the blower motor. Installation Procedure
2008 Chevrolet Silverado 1500 2008 HVAC Heating, Ventilation, and Air Conditioning - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
|
|
|