|
|
Content .. 1960 1961 1962 1963 ..
Fig. 223: Valve Lifter Oil Manifold 2. Install the valve lifter oil manifold (1) to the engine. 3. Install the valve lifter oil manifold bolts (2). Tighten: Tighten the bolts to 25 N.m (18 lb ft). NOTE: Refer to Fastener Notice .
2008 Chevrolet Silverado 1500 2008 ENGINE Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L, or 7.0L - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 224: View Of Engine Harness Electrical Connectors & Inlet Hose Clamp 4. Connect the engine harness electrical connector (1) to the oil pressure sensor. 5. Install the intake manifold. Refer to Intake Manifold Replacement (L92 - First Design) or Intake Manifold Replacement (L92 - Second Design) or Intake Manifold
2008 Chevrolet Silverado 1500 2008 ENGINE Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L, or 7.0L - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
L76). VALVE LIFTER OIL FILTER REPLACEMENT Removal Procedure Fig. 225: View Of Engine Harness Electrical Connectors & Inlet Hose Clamp
2008 Chevrolet Silverado 1500 2008 ENGINE Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L, or 7.0L - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
1. Remove the intake manifold. Refer to Intake Manifold Replacement (L92 - First Design) or Intake Manifold Replacement (L92 - Second Design) or Intake Manifold 2. Disconnect the engine harness electrical connector (1) from the oil pressure sensor. Fig. 226: View Of Oil Pressure Sensor 3. Remove the oil pressure sensor (1) and washer (2). 4. Remove and discard the valve lifter oil filter (3). 5. Remove and discard the valve lifter oil filter O-ring seal (4).
2008 Chevrolet Silverado 1500 2008 ENGINE Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L, or 7.0L - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Content .. 1960 1961 1962 1963 ..
|
|
|