|
|
Content .. 1514 1515 1516 1517 ..
Fig. 27: Installing Piston Into Bore 6. Position a piece of wood across the piston to be installed. 7. Applying equal pressure by hand while pushing down, install the piston in the bore. 8. Remove the piece of wood.
2008 Chevrolet Silverado 1500 2008 BRAKES Disc Brakes - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 28: View Of Bleeder Valve Cap 9. Install the bleeder valve in the brake caliper housing. NOTE: Refer to Fastener Notice .
2008 Chevrolet Silverado 1500 2008 BRAKES Disc Brakes - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Tighten: Tighten the bleeder valve to 12 N.m (106 lb in). 10. Install the bleeder valve cap. 11. Install the brake caliper. Refer to Front Brake Caliper Replacement (JH6, JH7) or Front Brake Caliper Replacement (JD9, JF3, JF7). REAR BRAKE CALIPER OVERHAUL (JH6, JH7) Disassembly Procedure 1. Remove the brake caliper. Refer to Rear Brake Caliper Replacement (JH6, JH7) or Rear Brake Caliper Replacement (JD9). 2. Drain all the brake fluid from the caliper. 3. Secure the brake caliper in a suitable holding device. 4. Insert a piece of wood in the brake caliper between the pistons and the outer bridge. CAUTION: Refer to Brake Dust Caution . CAUTION: Refer to Brake Fluid Irritant Caution . IMPORTANT: The brake calipers use phenolic pistons with stainless steel caps which contact the brake pads. Use compressed air to
2008 Chevrolet Silverado 1500 2008 BRAKES Disc Brakes - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 29: Applying Air To Brake Caliper 5. Cover the brake caliper with a shop towel. 6. Apply filtered, non-lubricated compressed air into the brake hose inlet fitting port of the brake caliper.
2008 Chevrolet Silverado 1500 2008 BRAKES Disc Brakes - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Content .. 1514 1515 1516 1517 ..
|
|
|