|
|
Content .. 1327 1328 1329 1330 ..
2. Install the front differential carrier shield bolts. Tighten: Tighten the front differential carrier shield bolts to 20 N.m (15 lb ft). 3. Lower the vehicle. VENT HOSE REPLACEMENT (8.25 INCH AXLE) Removal Procedure NOTE: Refer to Fastener Notice .
2008 Chevrolet Silverado 1500 2008 Driveline/Axle Front Drive Axle - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 32: Locating Vent Hose & Components 1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle . 2. Remove the engine shield, if equipped. Refer to Engine Shield Replacement . 3. Remove the vent hose the retainers from the frame. 4. Remove the vent hose from the connector. 5. Lower the vehicle.
2008 Chevrolet Silverado 1500 2008 Driveline/Axle Front Drive Axle - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 33: View Of Vent Hose 6. Remove the vent hose from the inner fender. Installation Procedure
2008 Chevrolet Silverado 1500 2008 Driveline/Axle Front Drive Axle - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
|
|
|