|
|
Fig. 90: View Of Water Pump Inlet Hose & Clamps 23. Reposition the water pump inlet hose clamps. 24. Remove the water pump inlet hose.
2008 Chevrolet Silverado 1500 2008 ENGINE Engine Mechanical - 4.3L - Sierra & Silverado
Fig. 91: View Of Power Steering Pump Bracket 25. In order to remove the front intake manifold bolt, perform the following: 1. Remove the drive belt. Refer to Drive Belt Replacement. 2. Loosen the power steering (P/S) pump rear bracket nut. 3. Remove the P/S pump rear bracket front nut. 4. Remove the bolts and the nut for the P/S pump bracket. 5. Leave the A/C compressor, if equipped, and the P/S pump on the bracket. 6. Slide the P/S pump bracket forward to access the front intake manifold bolt.
2008 Chevrolet Silverado 1500 2008 ENGINE Engine Mechanical - 4.3L - Sierra & Silverado
Fig. 92: Intake Manifold 26. Remove the intake manifold - lower bolts. 27. Remove the intake manifold. 28. Remove and discard the intake manifold gaskets.
2008 Chevrolet Silverado 1500 2008 ENGINE Engine Mechanical - 4.3L - Sierra & Silverado
29. Clean and inspect the intake manifold - lower, if necessary. Refer to Intake Manifold Cleaning and Inspection. Installation Procedure Fig. 93: Applying Patch Of Adhesive To Cylinder Head Side Of Intake Manifold NOTE: Apply the proper amount of the sealant when assembling this
2008 Chevrolet Silverado 1500 2008 ENGINE Engine Mechanical - 4.3L - Sierra & Silverado
|
|
|