|
|
4.6 engines often stalls Check step motor fault 1 check mount screw 2 short time vibration should be felt when ignition switch turned on
1 repair or replace step motor 2 check step motor wire 3 replace or turn idle motor mount screw
Check throttle position sensor
Throttle position sensor and its connection, repair or replace as necessary.
Check throttle valve gap; warm engine to 80℃, let engine idle, cut off A/C. Use scan tester to detect motor steps. The total steps is 20-30.
1 If steps is not within specification, adjust the initial angle of throttle valve, ensuring a correct total steps. 2 If there exists carbon or tar deposits, please remove it. Note: If reliable tool for testing total idle steps is not available, DO NOT adjust initial throttle angle.
Watch each cylinder firing check and ensure spark plug and plug gap is 8mm. NOTE: Measure compression pressure and air valve gap
1 replace spark plug 2 cylinder compression pressure 3 valve gap
Check air intake manifold pressure sensor
Check air intake pressure sensor and wire, repair or replace as necessary .
Check circuit connection
1 ECU voltage supply fusible link fuse 2 circuit wire test: using voltmeter or ohmmeter measure voltage or resistance Air system leakage check
|