|
|
|
FUNCTION
FUSE
AMPERAGE
Windshield washer pump
F43
20
Rear left power window
F47
25
Rear right power window
F48
25
Heater rear window coil
F94
15
181
Luggage Compartment Fuse Box
FUNCTION
FUSE
AMPERAGE
Tow hook module (TTM)
F1
40
Hi-Fi system
F8
30
KL15/a USB Recharge (C070)
F17
7.5
I-Drive / USB / AUX port
F21
10
KL15/a 12VPower outlet (R053)
F22
20
08036S0015EM
Luggage Compartment Control Unit
182
IN CASE OF EMERGENCY
TIRE SERVICE KIT
Description
If a tire is punctured, you can make an
emergency repair using theTire Service
Kit located in the trunk beneath the load
floor.
TheTire Service Kit includes:
Sealant cartridge containing the
sealing fluid.
Filler tube.
Adhesive label with the writing "Max.
50 mph (80 km/h)”, to be attached in a
position easily visible to the driver (eg. on
the dashboard) after repairing the tire.
Air compressor, complete with
pressure gauge and connectors.
An instruction pamphlet for reference
in prompt and correct use of theTire
Service Kit, which must be then given to
the personnel dealing with the
sealant-treated tire.
A pair of protective gloves.
Adaptors for inflating different
elements.
Note:
The sealant is effective with
external temperatures of between -40°F
(-40°C) and 122°F (50°C).The sealant
has an expiration date.
To use theTire Service Kit, proceed as
follows:
1. Stop the vehicle in a position where
you can repair the tire safely. You should
be as far as possible from the side of the
road, and in a position that is not
dangerous for oncoming traffic.
Activate the hazard warning flashers,
remove the safety triangle from the
trunk, and place it at a suitable distance
from the vehicle to make other drivers
aware of your presence.
2. Verify that the valve stem (on the
wheel with the deflated tire) is in a
position that is near to the ground.This
will allow the tire service kit hoses to
reach the valve stem and keep the tire
repair kit flat on the ground.
3. Place the gear selector to PARK (P).
4. Apply the electric park brake and
cycle the engine OFF.
Inflation Procedure
Warning!
Do not attempt to seal a tire on the side
of the vehicle closest to traffic. Pull far
enough off the road to avoid the danger of
being hit when using theTire Service Kit.
Do not useTire Service Kit or drive the
vehicle under the following circumstances:
If the puncture in the tire tread is
approximately 1/4 inch (6 mm) or larger.
If the tire has any sidewall damage.
If the tire has any damage from driving
with extremely low tire pressure.
If the tire has any damage from driving on
a flat tire.
If the wheel has any damage.
08066S0001EM
Tire Service Kit Location
08066S0002EM
Tire Service Kit Components
1 — Sealant Cartridge
2 — FillerTube
3 — Adhesive Label
4 — Air Compressor
183
If you are unsure of the condition of the
tire or the wheel.
KeepTire Service Kit away from open
flames or heat sources.
A looseTire Service Kit thrown forward in
a collision or hard stop could endanger the
occupants of the vehicle. Always stow the
Tire Service Kit in the place provided. Failure
to follow these warnings can result in
injuries that are serious or fatal to you, your
passengers, and others around you.
Take care not to allow the contents of
Tire Service Kit to come in contact with hair,
eyes, or clothing.Tire Service Kit sealant is
harmful if inhaled, swallowed, or absorbed
through the skin. It causes skin, eye, and
respiratory irritation. Flush immediately
with plenty of water if there is any contact
with eyes or skin. Change clothing as soon
as possible, if there is any contact with
clothing.
Tire Service Kit Sealant solution contains
latex. In case of an allergic reaction or rash,
consult a physician immediately. KeepTire
Service Kit out of reach of children. If
swallowed, rinse mouth immediately with
plenty of water and drink plenty of water.
Do not induce vomiting! Consult a physician
immediately.
To use yourTire Service Kit, proceed as
follows:
1. Apply the electric park brake.
2. Insert the sealant cartridge containing
the sealing fluid in the proper
compressor holder, pushing down hard.
Unscrew the tire valve cap, take out the
filler tube and tighten the fitting on the
tire valve.
3. Make sure the power switch of the
compressor is in the O (off) position.
4. Insert the plug into the power outlet in
the center console, then start the engine.
5. Start the compressor by placing the
power switch in the I (on) position.
6. Inflate the tire to the pressure
indicated on the tire placard, located on
the driver’s side B-Pillar or the rear edge
of the driver’s side door. Refer to “Tires”
in “Servicing And Maintenance” for more
information. In order to obtain a more
precise reading, check the pressure value
on pressure gauge with the compressor
off.
08066S0004EM
Attaching Filler Tube To Deflated Tire
1 — Sealant Cartridge
2 — FillerTube
08066S0006EM
Center Console Power Outlet
184
IN CASE OF EMERGENCY
|
|
|