|
|
|
Types Of Bulbs
The vehicle may be equipped with the following bulbs
Glass Bulbs (Type A)
: They are press-fitted. Pull to extract.
Bayonet-Type Bulbs (Type B)
: To remove them from their holder, press
the bulb and turn it counterclockwise, then extract it.
Tubular Bulbs (Type C)
: Release them from their contacts to remove.
Halogen Bulbs (Type D)
:To remove the bulb, turn the connector to the
side and pull it out.
Xenon Gas Discharge Bulb (Type F)
: To remove the bulb, contact an
authorized dealer.
173
Replacement Bulbs
Light bulbs
Type
Power
Front direction indicators
PY24W
24 W
Rear Fog lights
H11
55 W
Main beam headlights (Xenon gas discharge)
D5S
25 W
Main beam headlights (Xenon gas discharge)
D3S
35 W
Sun visor light
1.5CP
2.1 W
Glove compartment light
W5W
4 W
Trunk lid light
W5W
5 W
Puddle lights (under door panel)
W5W
5 W
Replacing Exterior Bulbs
Note:
Only replace the bulb when the
engine is off. Also ensure that the engine
is cold, to prevent the risk of burns.
Direction Indicators
To change the bulb of these lights,
proceed as follows:
1. Operating inside the engine
compartment, remove the protective
cover.
2. Remove protective cover.
3. Turn the bulb/connector assembly
counterclockwise, and then slide it off
the headlight body.
08026S0023EM
Protective Cover Location
08026S0006EM
Protective Cover
174
IN CASE OF EMERGENCY
4. Remove the bulb by sliding it off the
bulb holder.
5. Install the new bulb, making sure it is
correctly inserted in the bulb holder.
6. Insert the bulb/connector assembly in
the housing on the headlight body and
turn it clockwise, making sure that it is
locked correctly.
7. Install the protective cover.
Front Light Cluster with Main Beam
Xenon Gas Discharge Headlights
To replace the bulbs of the main beam
headlights, contact your authorized dealer.
Caution!
Do not touch the new bulb with your fingers.
Oil contamination will severely shorten bulb
life. If the bulb comes in contact with any oily
surface, clean the bulb with rubbing alcohol.
Replacing Interior Bulbs
Courtesy Mirror Light
To replace the bulbs, proceed as follows:
1. Lift the mirror cover and remove the
lens, using a suitable tool.
2. Change the bulb, releasing it from the
side contacts, then insert the new bulb,
making sure that it is correctly fastened
between the contacts.
3. Install the lens, inserting it firstly on
one side and then pressing on the other
side until it clicks into place.
Glove Compartment Light
To replace the bulb, proceed as follows:
1. Open the glove compartment.
2. Remove the courtesy light assembly,
using a suitable tool.
08026S0007EM
Bulb/Connector
08026S0008EM
Sun Visor
1 — Mirror Cover
2 — Lens
08026S0009EM
Courtesy Lamp Indent
175
3. Open protective cover up and remove
the bulb pulling out of the connector.
4. Install bulb, making sure that it is
correctly inserted fully.
5. Close the protective cover on the lens.
6. Install courtesy light, inserting it first
on one side and then pressing on the
other side until it clicks into place.
Luggage Compartment Courtesy Lights
To replace the bulbs, proceed as follows:
1. Open the trunk, and remove the trunk
lamp assembly using a suitable tool.
2. Open protective cover up and remove
the bulb pulling out of the connector.
3. Install bulb, making sure that it is
correctly inserted fully.
4. Close the protective cover on the lens.
5. Install trunk lamp in the correct
position, inserting it firstly on one side,
and then pressing on the other side until
it clicks into place.
Puddle Lights On Door Panel
To replace the bulb, proceed as follows:
1. Open the door and remove the puddle
light assembly, using a suitable tool.
2. Open protective cover up and remove
the bulb pulling out of the connector.
08026S0011EM
Cover And Bulb Removal Direction
08026S0010EM
Ceiling Light Indent
08026S0011EM
Cover And Bulb Removal Direction
08026S0012EM
Puddle Light Indent
176
IN CASE OF EMERGENCY
|
|
|