Acura TSX / Honda Accord CL. Manual - part 323

 

  Index      Acura     Acura TSX 2004-2008 / Honda Accord CL 2006-2008 - service repair manual

 

Search            copyright infringement  

 

 

 

 

 

 

 

 

 

Content   ..  321  322  323  324   ..

 

 

Acura TSX / Honda Accord CL. Manual - part 323

 

 

1. Remove the drive belt. See DRIVE BELT .  

2. Remove the Power Steering (P/S) pump without disconnecting the P/S hoses. See Fig. 13 .  

3. Remove the auto-tensioner. See Fig. 14 .  

4. Install the auto-tensioner in the reverse order of removal.  

Fig. 13: Removing Power Steering Pump 
Courtesy of AMERICAN HONDA MOTOR CO., INC.

 

2004 Acura TSX 

2004 STARTING & CHARGING SYSTEMS Generators & Regulators - TSX

  

 

Fig. 14: Removing/Installing Auto-Tensioner 
Courtesy of AMERICAN HONDA MOTOR CO., INC. 

TENSIONER PULLEY 

 

2004 Acura TSX 

2004 STARTING & CHARGING SYSTEMS Generators & Regulators - TSX

  

 

Replacement 

1. Remove the drive belt. See DRIVE BELT .  

2. Remove the pulley bolt "A", and remove the tensioner pulley "B".  

3. Install the tensioner pulley in the reverse order of removal. See Fig. 15 .  

Fig. 15: Removing/Installing Tensioner Pulley 
Courtesy of AMERICAN HONDA MOTOR CO., INC. 

OVERHAUL 

ALTERNATOR 

Disassembly 

NOTE:

For overhaul information, see exploded view of alternator. See Fig. 16 .

 

2004 Acura TSX 

2004 STARTING & CHARGING SYSTEMS Generators & Regulators - TSX

  

 

Fig. 16: Exploded View Of Alternator 
Courtesy of AMERICAN HONDA MOTOR CO., INC. 

1. Test the alternator and regulator before you remove them. See CHARGING SYSTEM INDICATOR 

TEST under TROUBLE SHOOTING.  

2. Remove the alternator. See ALTERNATOR under REMOVAL & INSTALLATION.  

3. If the front bearing needs replacing, remove the pulley locknut with a 10-mm wrench "A" and a 22-mm 

wrench "B". If necessary, use an impact wrench. See Fig. 17 .  

4. Remove harness stay and flange nuts. See Fig. 18 .  

5. Remove the end cover. See Fig. 19 .  

6. Remove the brush holder. See Fig. 20 .  

7. Remove the 4 bolts. Remove the rear housing assembly "A", and washer "B". See Fig. 21 .  

8. If you are not replacing the front bearing "A", go to BRUSHES . Remove the rotor from the stator drive-

end housing. See Fig. 22 .  

9. Inspect the rotor shaft for scoring, and inspect the bearing journal surface in the stator housing for seizure 

marks. If either the rotor or stator housing is damaged, replace the alternator. If both the rotor and the 
stator housing are OK, go to next step. 

 

2004 Acura TSX 

2004 STARTING & CHARGING SYSTEMS Generators & Regulators - TSX

  

 

 

 

 

 

 

 

 

Content   ..  321  322  323  324   ..