|
|
Fig. 13: Disconnecting The 3P Connector From The Key Cylinder Switch 3. Check for continuity between the terminals. z There should be continuity between the No. 2 and No. 3 terminals when the door key cylinder z There should be no continuity between the No. 2 and No. 3 terminals when the door key cylinder z There should be continuity between the No. 1 and No. 2 terminals when the door key cylinder z There should be no continuity between the No. 1 and No. 2 terminals when the door key cylinder 4. If the continuity is not as specified, replace the door key cylinder assembly (see FRONT DOOR OUTER HANDLE REPLACEMENT ). CONTROL UNIT INPUT TEST 1. Before testing the keyless entry/security control functions, troubleshoot the multiplex integrated control system. (see MULTIPLEX INTEGRATED CONTROL UNIT INPUT TEST ). Multiplex Integrated Control Unit: 2. Remove the left kick panel (see TRIM REMOVAL/INSTALLATION - DOOR AREA ). 3. Disconnect the under-dash fuse/relay box connectors. NOTE: All connectors are wire side of female terminals.
2004 Acura TSX 2004 ACCESSORIES & EQUIPMENT Keyless Entry/Security Alarm System - TSX
|