|
|
03 Initializing the OPDS (Occupant Position Troubleshooting Intermittent Failures 23-24 SRS General Troubleshooting Information (cont’d) A When a seat-back cover, seat-back cushion, and/or NOTE: A new (uninitialized) OPDS unit installed with a 1. Erase the DTC memory (see ‘‘Erasing the DTC Memory’’). 2. Make sure the front passenger’s seat is dry. Set the seat-back in a normal position, and make sure there 3. Make sure the ignition switch is OFF and the MES connector is not shorted. 4. Connect the HDS to the DLC (A). 5. Turn the ignition switch ON (II). 6. From the HDS Main Menu, select SRS, then Misc Test, then adjustments. In the Adjustment Menu, 7. Turn the ignition switch OFF. 8. Disconnect the HDS from the DLC. NOTE: If the OPDS system fails to initialize after If there was a malfunction, but it doesn’t recur, it will be After checking the DTC, troubleshoot as follows: 1. Read the DTC (see ‘‘Reading the DTC’’). 2. Erase the DTC memory (see ‘‘Erasing the DTC Memory’’). 3. Set the parking brake, start the engine, and let it idle. 4. The SRS indicator will come on for about 6 seconds and then go off. 5. Shake the wire harness and the connectors, take a test-drive (quick acceleration, quick braking, 6. If you can’t duplicate the intermittent failure, the system is OK at this time. 05/06/27 18:08:40 61S6M040_230_0024 |