Acura RSX Honda Integra. Manual - part 52
０５
０２
０２
０６
6-52
Cylinder Head
Cylinder Head Installation (cont’d)
FIRST STEP
SECOND STEP
THIRD STEP
(New bolt)
D
A
C
6 x 1.0 mm
12 N·m (1.2 kgf·m, 8.7 lbf·ft)
B
6 x 1.0 mm
12 N·m
(1.2 kgf·m, 8.7 lbf·ft)
B
A
9. After torquing, tighten all cylinder head bolts in two
steps (90 ° per step). If you are using a new cylinder
head bolt, tighten the bolt an extra 90 °.
NOTE: Remove the cylinder head bolt if you
tightened it beyond the specified angle, and go
back to step 5 of the procedure. Do not loosen it
back to the specified angle.
10. Install the rocker arm assembly (see page 6-50).
11. Install the water bypass hose (A).
12. Tighten the connecting pipe mounting bolt (B) and
water bypass line mounting bolts (C), then install
the harness holder (D) on the bracket.
13. Install the upper radiator hose (A) and heater hose
(B).
14. Install the water bypass hose.
15. Install the intake manifold:
• K20A3 engine (see page 9-5)
• K20A2, K20Z1 engines (see page 9-11)
16. Install the exhaust manifold (see page 9-14).
17. Install the cam chain (see page 6-17).
18. K20A3 engine: Install the fuel feed hose (see page
11-370).
19. Adjust the valve clearance (see page 6-11).
20. Install the drive belt (see page 4-43).
21. Clean the battery posts and cable terminals with
sandpaper, then assemble them and apply grease
to prevent corrosion.