|
|
63 OPERATION Reverse Operation Electronic Reverse (PERCt) Electronic reverse will activate only if the engine is below 4000 RPM. If your machine is running at an altitude of over 6000 feet, adjust the ignition setting as described below. Always make sure the vehicle is stopped and the engine is running at idle before shifting to reverse. 2. Push the yellow reverse button on the left-hand control for one second, then release. The engine will automatically reduce RPM and start a reverse rotation. A flashing reverse light on the instrument panel will indicate that the machine is in reverse. 3. Slowly apply the throttle until movement starts and you’re sure the machine is in reverse. NOTE: The maximum engine RPM will be 6000 when in reverse. ward gear when it’s restarted. Disengaging Reverse and release. The engine will slow and and begin to rotate forward. The light on the instrument panel will shut off. Make sure the area around your vehicle is clear and apply throttle slowly until you’re sure the machine is in forward gear. ignition setting to improve the success of the reverse system. To set for a higher altitude, start the engine and hold the button down until the light on the instrument panel flashes rapidly, then release the button. down until the reverse indicator light blinks slowly. Once set, it’s stored in memory until changed, whether the machine is running or not. Operating the electric starter or the recoil while the engine is running can result in personal injury and/or engine damage. Do not operate the electric or pull-rope starter while the engine is running. CAUTION |