|
|
DLK-366 < DTC/CIRCUIT DIAGNOSIS > AUTOMATIC SLIDING DOOR WARNING BUZZER Is the inspection result normal? YES >> INSPECTION END NO >> Replace automatic sliding door warning buzzer LH. SLIDING DOOR RH SLIDING DOOR RH : Diagnosis Procedure INFOID:0000000009649319 1. CHECK FUSE 1. Turn ignition switch OFF. 2. Check 10 A fuse, [No.9, located in fuse block (J/B)] Is the inspection result normal? YES >> GO TO 2. NO >> Replace the blown fuse after repairing the affected circuit if a fuse is blown. 2. CHECK AUTOMATIC SLIDING DOOR WARNING BUZZER INPUT SIGNAL 1. Disconnect automatic sliding door warning buzzer RH connector. 2. Check voltage between automatic sliding door warning buzzer RH harness connector and ground. Is the inspection result normal? YES >> GO TO 3. NO >> Repair or replace harness. 3. CHECK AUTOMATIC SLIDING DOOR WARNING BUZZER CIRCUIT 1. Disconnect sliding door control unit RH connector. 2. Check continuity between sliding door control unit RH harness connector and automatic sliding door 3. Check continuity between sliding door control unit RH harness connector and ground. Is the inspection result normal? YES >> GO TO 4. NO >> Repair or replace harness. 4. CHECK AUTOMATIC SLIDING DOOR WARNING BUZZER DLK-367, "SLIDING DOOR RH : Component Inspection" Is the inspection result normal? YES >> Replace sliding door control unit RH. Refer to DLK-500, "RH : Removal and Installation" NO >> Repair or replace harness. Automatic sliding door warning buzzer LH Operation Terminal (+) ( − ) 1 2 Buzzer sounds (+) ( − ) Voltage Automatic sliding door warning buzzer RH Connector Terminal B203 1 Ground 8 – 16 V Sliding door control unit RH Automatic sliding door warning buzzer RH Continuity Connector Terminal Connector Terminal B247 8 B203 2 Existed Sliding door control unit RH Ground Continuity Connector Terminal B247 8 Not existed |