|
|
TM-150 < DTC/CIRCUIT DIAGNOSIS > [4AT: RE4F03C] P0711 TRANSMISSION FLUID TEMPERATURE SENSOR A 2. CHECK A/T FLUID TEMPERATURE SENSOR FUNCTION With CONSULT 1. Cool the engine. 2. Turn ignition switch ON. CAUTION: Never start the engine. 3. Select “FLUID TEMP” in “Data Monitor” in “TRANSMISSION”. 4. Select “COOLANT TEMP/S” in “Data Monitor” in “ENGINE”. 5. Check temperature difference between A/T fluid and engine coolant. With GST 1. Complete engine diagnoses P0111, P0116, and P0196. 2. After starting the engine start, run the engine at idle for 5 minutes. 3. Check the DTC. 38 °C (100.4°F) or is it less than −27°C (−16.6°F)? (With CONSULT)/Is “P0711” detected? (With GST) YES >> Go to NO-1 [With CONSULT: “FLUID TEMP” is 15 °C (59°F) or more]>>INSPECTION END NO-2 [With CONSULT: “FLUID TEMP” is 14 °C (57.2°F) or less]>>GO TO 3. NO-3 (With GST)>>GO TO 3. 3. CHECK DTC DETECTION With CONSULT 1. Select “SLCT LVR POSI”, “VHCL/S SE-AT”, “ACCELE POSI”, “FLUID TEMP” in “Data Monitor” in “TRANSMISSION”. 2. Record A/T fluid temperature. 3. Start the engine and wait for at least 3 minutes. 4. Drive the vehicle for the total minuets specified in the Driving time column below with the following condi- tions satisfied. 5. Perform “Self Diagnostic Results” in “TRANSMISSION”. With GST 1. Cool the engine. 2. Start the engine and wait for at least 3 minutes. 3. Drive the vehicle and maintain the following conditions for 21 minutes or more. 4. Check the DTC. YES >> Go to NO >> INSPECTION END SLCT LVR POSI : D VHCL/S SE-AT : 10 km/h (7 MPH) or more ACCELE POSI : 1.0/8 or more A/T fluid temperature before engine start Driving time −40°C (−40°F) – −31°C (−23.8°F) 20 minutes or more −30°C (−22°F) – −21°C (−5.8°F) 19 minutes or more −20°C (−4°F) – −11°C (12.2°F) 15 minutes or more −10°C (14°F) – −1°C (30.2°F) 12 minutes or more 0 °C (32°F) – 9°C (48.2°F) 9 minutes or more 10 °C (50°F) – 14°C (57.2°F) 5 minutes or more Selector lever : D position Vehicle speed : 10 km/h (7 MPH) or more Accelerator pedal opening : 1.0/8 or more |