|
|
содержание .. 12 13 14 15 ..
ADP-48 < DTC/CIRCUIT DIAGNOSIS > B2116 TILT MOTOR B2116 TILT MOTOR Description INFOID:0000000005515314 • The tilt motor is installed to the steering column assembly. DTC Logic INFOID:0000000005515315 DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1. STEP 1 Turn ignition switch ON. >> GO TO 2. 2. STEP 2 Check “Self diagnostic result” with CONSULT-III. Is the DTC detected? YES >> Perform diagnosis procedure. Refer to NO >> INSPECTION END Diagnosis Procedure INFOID:0000000005515316 1. PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check “Self diagnostic result” with CONSULT-III. 3. Erase the DTC. 4. Perform DTC confirmation procedure. Refer to . Is the DTC displayed again? YES >> GO TO 2. NO >> Check intermittent incident. Refer to GI-39, "Intermittent Incident" . 2. CHECK TILT MOTOR CIRCUIT (POWER SHORT) 1. Turn ignition switch OFF. 2. Disconnect automatic drive positioner control unit and tilt motor connector. 3. Check voltage between tilt motor harness connector and ground. Is the inspection result normal? YES >> GO TO 3. NO >> Repair or replace harness or connector. 3. CHECK AUTOMATIC DRIVER POSITIONER CONROL UNIT OUTPUT SIGNAL 1. Connect automatic drive positioner control unit connector. DTC No. Trouble diagnosis name DTC detecting condition Possible cause B2116 STEERING TILT The automatic drive positioner control unit detects the • Automatic drive positioner control unit • Tilt motor harness is shorted (+) (–) Voltage (V) (Approx.) Tilt motor Connector Terminals M116 1 Ground 0 2 |