|
|
Content .. 1268 1269 1270 1271 ..
TM-270 < DTC/CIRCUIT DIAGNOSIS > [CVT: RE0F10B] P0826 UP AND DOWN SHIFT SW Is the inspection result normal? YES >> GO TO 4. NO >> GO TO 5. 4. CHECK MANUAL MODE SWITCH 1. Turn ignition switch OFF. 2. Check manual mode switch. Refer to TM-272, "Component Inspection (Manual Mode Switch)" Is the inspection result normal? YES >> GO TO 7. NO >> Repair or replace damaged parts. 5. CHECK CIRCUIT BETWEEN CVT SHIFT SELECTOR AND COMBINATION METER (PART 1) 1. Turn ignition switch OFF. 2. Disconnect combination meter connector. 3. Check continuity between CVT shift selector harness connector terminals and combination meter harness connector terminals. Is the inspection result normal? YES >> GO TO 6. NO >> Repair or replace damaged parts. 6. CHECK CIRCUIT BETWEEN CVT SHIFT SELECTOR AND COMBINATION METER (PART 2) Check continuity between CVT shift selector harness connector terminals and ground. Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-45, "Intermittent Incident" . + − Condition Voltage (Approx.) CVT shift selector Connector Terminal M57 7 Ground Ignition switch: ON 12 V Ignition switch: OFF 0 V 8 Ignition switch: ON 12 V Ignition switch: OFF 0 V 9 Ignition switch: ON 12 V Ignition switch: OFF 0 V 11 Ignition switch: ON 12 V Ignition switch: OFF 0 V CVT shift selector Combination meter Continuity Connector Terminal Connector Terminal M57 7 M34 36 Existed 8 16 9 14 11 37 CVT shift selector — Continuity Connector Terminal M57 7 Ground Not existed 8 9 11 |