|
|
MANUAL TRANSAXLE J–21 J Synchronizer Ring and Clutch Hub Component Inspection 1. Inspect the clutch hub sleeve, clutch hub, and synchronizer key contact surface for damage and • If there is malfunction, replace the part where 2. Verify that the clutch hub sleeve and clutch hub move smoothly. • If there is malfunction, replace parts as 3. Inspect the synchronizer ring teeth and grooves for damage, abnormal wear, and cracks. • If there is malfunction, replace the 4. Inspect the tapered surface for abnormal wear and cracks. • If there is malfunction, replace parts as Synchronizer Ring Clearance Inspection 1. Measure the clearance of synchronizer component outer, middle and inner synchronizer • If clearances A and B exceed the maximum, (1) Measure clearance A in two places or more and on opposite sides using a dial gauge, and Clearance A Standard: 0.60—0.80 mm {0.0236—0.0315 in} Maximum: 0.20 mm {0.0079 in} or less AME5112M045 AME5112M046 AME5112M059 AME5112M129 |