|
|
содержание .. 172 173 174 175 ..
ABS-112 S5 Service manual S5 Инструкция по техобслуживанию Anti-lock Braking System Антиблокировочная Тормозная Система C003A(03) - Rear Right Wheel Speed Sensor: Fail Signal/ No Signal Сигнала Цепи Circuit Descriptions: Описание Цепи: When wheel is rotating, with the increase of wheel speed, speed sensor can produce a squre wave signal. ECU uses the frequency of this square wave signal to calculate wheel speed. Speed sensor is connected to ECU control module by «twisted pair wire». сигнал прямоугольного колебания. ECU использует частоту этого сигнала прямоугольного коле- бания для расчета скорости колеса. Датчик скорости подключен к блоку управления ECU витой парой. Conditions for Setting DTC: Условия для Установки DTC. DTCC003A (03) can be set only when all the following conditions occur: 1. DTCC0031 (0C) or C0034(0C) or C0037(0C) or C003A(0C) is not current. 2. Disable relevant functions. 3. Disconnect brake switch. Rear left wheel speed equals to 0, and all other wheel speed sensors are: at least more than 8km/h within 2.5 s. 3. Отключите тормозной переключатель. Скорость заднего левого колеса равна 0, а скорости других колес: больше чем 8 км/ч в течении 2.5 сек. Conditions for Clearing DTC: Условия Очистки DTC: 1. If the condition for setting DTCC003A (03) disappears, DTC can be cleared by using proper diag- nosis tester. 1. Если условие установления кода DTC C003A (03) исчезает, DTC может быть очищен при по- мощи диагностического прибора. 2. DTC which doesn't appear during 40 ignition cycles will be cleared from history data. истории. Diagnosis Assistance: Помощь при Диагностике: When intermittent DTC is detected, please completely inspect wiring and connectors. водку и разъемы. This will include: 1. Dismantle protective guide pipe, and inspect whether circuit is damaged, has short-circuit or con- taminated. |