|
|
INITIALIZATION After reconnecting battery cable, perform initialization procedure A or B. If initialization has not been performed, , close , open driver side door. (Do not perform with the door switch operation.) (3) End MEMORY AUTOMATIC SET Two drive positions can be retained in the memory. Press memory switch to set driver’s seat to preset posi- Adjust the position of driver’s seat, steering column with manual set operations. Ignition switch “ON”. H Touch set switch. Indicator LEDs (1) Indicator LED for which driver’s seat positions are already retained in memory illuminates for 5 seconds. (2) Indicator LED for which driver’s seat positions are not entered in memory illuminates for 0.5 seconds. Within 5 seconds. H Press memory switch for which driv- Indicator LEDs (1) To modify driver’s seat positions, press memory switch. Indicator LED will then go out for 0.5 seconds and then illuminate for 5 seconds. (2) To enter driver’s seat positions in blank memory, indicator LED illuminates for 5 seconds after memory switch is pressed. H END OF MEMORY SETTING NOTE: (1) When memory switch for which driver’s seat positions are already retained in memory is pressed, new seat positions will be retained in memory in place of the previously set positions. (2) Drive position is erased from the memory when battery cable is disconnected. After connecting battery cable, perform ini- tialization procedures. GI MA EM LC EC FE AT PD FA RA BR ST RS BT HA IDX AUTOMATIC DRIVE POSITIONER — IVMS System Description (Cont’d) EL-443 |