|
|
ADP-102 < COMPONENT DIAGNOSIS > LIFTING SENSOR (FRONT) 4. Check continuity between driver seat control unit harness connector and ground. Is the inspection result normal? YES >> GO TO 3. NO >> Repair or replace harness. 3. CHECK LIFTING SENSOR (FRONT) POWER SUPPLY 1. Connect driver seat control unit connector. 2. Turn ignition switch ON. 3. Check voltage between lifting motor (front) harness connector and ground. Is the inspection result normal? YES >> GO TO 5. NO >> GO TO 4. 4. CHECK LIFTING SENSOR (FRONT) POWER SUPPLY CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect driver seat control unit connector. 3. Check continuity between driver seat control unit harness connector and lifting motor (front) harness con- 4. Check continuity between driver seat control unit harness connector and ground. Is the inspection result normal? YES >> GO TO 7. NO >> Repair or replace harness. 5. CHECK LIFTING SENSOR (FRONT) GROUND 1. Turn ignition switch OFF. 2. Disconnect driver seat control unit connector. 3. Check continuity between driver seat control unit harness connector and lifting motor (front) harness con- Is the inspection result normal? YES >> GO TO 6. NO >> Repair or replace harness. 6. CHECK SEAT OPERATION 1. Connect driver seat control unit connector and lifting motor (front) connector. Driver seat control unit connector Terminal Ground Continuity B503 25 Not existed Terminals Voltage (V) (Approx.) (+) (–) Lifting motor (front) connector Terminal B527 16 Ground 5 Driver seat control unit connec- tor Terminal Lifting motor (front) connector Terminal Continuity B503 16 B527 16 Existed Driver seat control unit connec- tor Terminal Ground Continuity B503 16 Not existed Driver seat control unit connector Terminal Lifting motor (front) connector Terminal Continuity B503 31 B527 31 Existed |