Infiniti FX35 / FX45. Manual - part 75

AT-228

< SERVICE INFORMATION >

ON-VEHICLE SERVICE

12. Remove output shaft from transmission case by rotating left/

right.

13. Remove parking gear from output shaft.

14. Remove seal rings from output shaft.

15. Remove needle bearing from rear extension.

16. Remove parking actuator support from rear extension.

SCIA5246E

SCIA5247E

SCIA5209E

SCIA6021E

SCIA3423E

ON-VEHICLE SERVICE

AT-229

< SERVICE INFORMATION >

D

E

F

G

H

I

J

K

L

M

A

B

AT

N

O

P

17. Remove parking pawl (with return spring) and pawl shaft from

rear extension.

18. Remove return spring from parking pawl.

19. Remove rear oil seal from rear extension.

CAUTION:

Be careful not to scratch rear extension.

INSPECTION

• If the contact surface on parking actuator support, parking pawl,

etc. has excessive wear, abrasion, bend, or any other damage,
replace the components.

SCIA3424E

SCIA2445E

SCIA3524E

SCIA5143E

AT-230

< SERVICE INFORMATION >

ON-VEHICLE SERVICE

INSTALLATION

CAUTION:

After completing installation, check A/T position, A/T fluid leakage and A/F fluid level. Refer to 

AT-207,

"Checking of A/T Position"

, 

AT-11, "Checking A/T Fluid"

.

1.

As shown in the figure, use a drift to drive rear oil seal into the
rear extension until it is flush.

CAUTION:

• Do not reuse rear oil seal.
• Apply ATF to rear oil seal.

2.

Install return spring to parking pawl.

3.

Install parking pawl (with return spring) and pawl shaft to rear
extension.

SCIA5144E

SCIA5311E

SCIA2445E

SCIA3424E

ON-VEHICLE SERVICE

AT-231

< SERVICE INFORMATION >

D

E

F

G

H

I

J

K

L

M

A

B

AT

N

O

P

4.

Install parking actuator support to rear extension.

5.

Install needle bearing to rear extension.

CAUTION:

• Take care with the direction of needle bearing. Refer to

AT-264, "Location of Adjusting Shims, Needle Bearings,
Thrust Washers and Snap Rings"

.

• Apply petroleum jelly to needle bearing.

6.

Install seal rings in output shaft.

CAUTION:

• Do not reuse seal rings.
• Apply petroleum jelly to seal rings.

7.

Install parking gear to output shaft

8.

Install output shaft to transmission case.

SCIA3423E

SCIA6021E

SCIA5209E

SCIA5247E

SCIA5246E