|
|
Content .. 1054 1055 1056 1057 ..
MA-14 < ON-VEHICLE MAINTENANCE > ENGINE MAINTENANCE 6. Fill radiator, and reservoir tank if removed, to specified level. slowly of less than 2 (2-1/8 US qt, 1-3/4 lmp qt) a minute • Use Genuine NISSAN Long Life Antifreeze/Coolant or equivalent mixed with water (distilled or demineralized). MA-10, "Fluids and Lubricants" 7. When engine coolant overflows air relief hole on radiator, install air relief plug with new O-ring. 8. Repeat step 6. 9. When engine coolant overflows air relief hole on heater hose, install air relief plug with new O-ring. Then 10. Install radiator cap. 11. Warm up engine until opening thermostat. Standard for warming-up time is approximately 10 minutes at 3,000 rpm. CAUTION: Watch water temperature gauge so as not to overheat engine. 12. Stop the engine and cool down to less than approximately 50 ° C (122 ° F). • Cool down using fan to reduce the time. 13. Refill reservoir tank to “MAX” level line with engine coolant. 14. Repeat steps 10 through 13 two or more times with radiator cap installed until engine coolant level no longer drops. 15. Check cooling system for leakage with engine running. 16. Warm up the engine, and check for sound of engine coolant flow while running engine from idle up to 3,000 rpm with heater temperature controller set at several position between “COOL” and “WARM”. 17. Repeat step 16 three times. coolant level no longer drops. 19. Check that the reservoir tank cap is tightened. ENGINE COOLANT : Flushing INFOID:0000000003556576 1. Install reservoir tank if removed, and radiator drain plug. Engine coolant capacity : Refer to "Periodical Maintenanc (With reservoir tank at Reservoir tank engine cool- "Periodical Maintenanc . (At “MAX” level) A : MAX B : MIN JPBIA0412ZZ JPBIA0102ZZ Tightening torque : Refer to . : 1.2 N·m (0.12 kg-m, 11 in-lb) |