|
|
CD Player and Air Conditioning System-10 Refrigeration of air conditioner failed Trouble Descriptions Analysis of the Cause 1.No pick-up of compressor 1. fuse burned down, compressor’ s relay damaged 2. pressure switch contact disconnected, short circuit or open circuit of the routing 3. open circuit of clutch’s winding 4. switch burned down 5. master relay burned down 6. slide of the clutch 7. belt of the compressor broke or too loose 8. compressor failure 9. sensor failure(judged by reading the failure code) 10. insufficient cold media, lower systempressure(< 0.97MPa) 11. system pressure above 1.37MPa 12. water temperature of the engine too high 13.V oltage of the clutch below 7V 2. Pick-up of Compressor 1. normally-open contact of the compressor’ s relay stuck and serious leakage of system cold media, systemrunning short of cold media 2. no wind fromthe blower Refrigeration of air conditioning system failed 3. no wind from the blower 1. fuse burned down 2. motor brush of the blower damaged 3. switch of the blower damaged 4. coming off of distribution wire connectors or circuit disconnected 5. speed-adjusting module damaged 6. no wind fromthe blower when at high speed, high-speed relay damaged Press down “Temp+” switch Step 11: display “11”(set the temperature zone) Action of the executor mechanism: Attention: during the inspection period from step 7 to step 11, the controller will forcibly transit the output signal based on the code number displayed on the integrated display screen to the functioned executor; the inspection must be done with such methods as visual inspection, listening to abnormal sound or touching the air vent by hand so as to judge whether there is any improper operation. Trouble Diagnosis and Troubleshooting of A i r Conditioning System |