|
|
TEST ACTION APPLICABILITY 2 Ignition on, engine not running. t, erase Transmission DTCs. Raise the vehicle on the hoist. t in Sensors, monitor the N2 and N3 Speed Sensors. Firmly apply the brakes and place the gear selector in Drive (D). All Yes → Go To 3 No → Go To 5 3 Remove the Transmission Oil Pan and inspect for debris or a plugged Transmission All Yes → Repair Internal Transmission as necessary. Pay particular atten- tion to the Electrohydraulic Control unit. Refer to the Service No → Go To 4 4 If there are no possible causes remaining, view repair. All Repair Replace the Transmission Control Module. 5 The conditions necessary to set this DTC are not present at this time. All Yes → Repair as necessary Perform NAG1 TRANSMISSION VERIFICATION TEST - VER 1. No → Test Complete. 81 TRANSMISSION - NAG1 INPUT SENSOR OVERSPEED — Continued |