Chrysler RG Voyager. Manual - part 386
Symptom:
P0235-BOOST PRESSURE SENSOR SIGNAL VOLTAGE TOO HIGH
When Monitored and Set Condition:
P0235-BOOST PRESSURE SENSOR SIGNAL VOLTAGE TOO HIGH
When Monitored:
With the ignition on.
Set Condition:
The Boost Pressure Sensor Signal voltage exceeds 4.85 volts for at least 2
seconds.
POSSIBLE CAUSES
INTERMITTENT CONDITION
BOOST PRESSURE SENSOR GROUND CIRCUIT SHORTED TO VOLTAGE
BOOST PRESSURE SENSOR SIGNAL CIRCUIT SHORTED TO VOLTAGE
BOOST PRESSURE SENSOR GROUND CIRCUIT OPEN
BOOST PRESSURE SENSOR
POOR CONNECTOR TERMINAL CONTACT
ENGINE CONTROL MODULE (INTERNAL)
ENGINE CONTROL MODULE (SENSOR SIGNAL SHORTED TO VOLTAGE)
TEST
ACTION
APPLICABILITY
1
NOTE: If the ECM detects and stores a DTC, the ECM also stores the
engine/vehicle operating conditions under which the DTC was set. Some of
these conditions are displayed on the DRB at the same time the DTC is
displayed.
NOTE: Before erasing stored DTCs, record these conditions. Attempting to
duplicate these conditions may assist when checking for an active DTC.
NOTE: Ensure all turbocharger inlet and outlet tubes are connected prop-
erly, without damage and restriction before continuing with this test. Also
ensure the wastegate actuator and actuator rod are attached and function-
ing properly.
NOTE: If a P0243 DTC is present with this DTC, diagnose P0243 DTC before
continuing.
Turn the ignition on.
With the DRB, erase ECM DTCs.
Cycle the ignition key on and off several times, leaving the key on for at least 10
seconds at a time.
With the DRB, read ECM DTCs.
Did this DTC set again?
All
Yes
→ Go To 2
No
→ Go To 8
47
DRIVEABILITY - DIESEL