TEST
ACTION
APPLICABILITY
8
Disconnect the Left and Right Power Mirror connectors.
Disconnect the Body Control Module C2 connector.
NOTE: Check connectors - Clean/repair as necessary.
Measure the resistance between ground and the Driver Folding Mirror Fold Driver
circuit in the BCM C2 connector.
Is the resistance below 5.0 ohms?
All
Yes
→ Repair the Driver Folding Mirror Fold Driver circuit for a short to
ground.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Go To 9
9
Disconnect the Left and Right Power Mirror connectors.
Disconnect the Passenger Folding Mirror Relay.
NOTE: Check connectors - Clean/repair as necessary.
Measure the resistance between ground and the Passenger Folding Mirror Relay
Output circuit in the relay connector.
Is the resistance below 5.0 ohms?
All
Yes
→ Repair the Passenger Folding Mirror Relay Output circuit for a
short to ground.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Go To 10
10
Disconnect the Body Control Module C2 connector.
Disconnect the Passenger Folding Mirror Relay.
NOTE: Check connectors - Clean/repair as necessary.
Measure the resistance between ground and the Passenger Folding Mirror Relay
Input circuit in the relay connector.
Is the resistance below 5.0 ohms?
All
Yes
→ Repair the Passenger Folding Mirror Relay Input circuit for a
short to ground.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
1105
POWER MIRROR
UNFOLD MIRROR OUTPUT FAILURE (EXPORT ONLY) —
Continued