|
|
Content .. 1464 1465 1466 1467 ..
2. Install the J 44420 (2) and the J 8092 (1) onto the differential case bearing as shown. See Special Tools. 3. Drive the bearing onto the case using the J 44420 and the J 8092 . See Special Tools. DIFFERENTIAL OVERHAUL (9.5/9.5LD INCH AXLES) Tools Required J 8092 Universal Driver Handle - 3/4 in - 10 J 22888-D Side Bearing Puller Kit J 29710 Differential Side Bearing Installer J 36597 Side Bearing Puller Pilot - 9.25 inch Disassembly Procedure
2008 Chevrolet Silverado 1500 2008 Driveline/Axle Rear Drive Axle - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 232: Removing Differential Side Bearing 1. Remove the differential side bearings by performing the following steps: 1. Install the differential assembly into a vise. 2. Install the J 36597 (1) and the J 22888-20A (2) as shown. See Special Tools. 3. Remove the differential side bearings using the J 22888-20A . See Special Tools.
2008 Chevrolet Silverado 1500 2008 Driveline/Axle Rear Drive Axle - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 233: Identifying Ring Gear Bolts 2. Remove the gear bolts. Discard the bolts. IMPORTANT: The ring gear bolts have left-hand threads.
2008 Chevrolet Silverado 1500 2008 Driveline/Axle Rear Drive Axle - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 234: Removing Ring Gear From Differential 3. Remove the ring gear from the differential case. Drive the ring gear off with a brass drift if necessary. NOTE: Refer to Ring Gear Removal Notice .
2008 Chevrolet Silverado 1500 2008 Driveline/Axle Rear Drive Axle - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Content .. 1464 1465 1466 1467 ..
|
|
|