BMW 3 (E46). Manual - part 276

 

  Index      BMW     BMW 3 (E46) - service repair manual 2006 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  274  275  276  277   ..

 

 

BMW 3 (E46). Manual - part 276

 

 

 -

Installation is reverse of removal,
noting the following:

Sedan/Sport Wagon: Foglight
must be snapped firmly into
bumper retainers.

Coupe/Convertible: Keep
ventilation grommets unkinked
and firmly seated.

Adjust foglight aim as described
earlier.

 

 

Foglight bulb, replacing

 -

Remove foglight assembly as
described earlier.

Twist and remove bulb from rear
of foglight assembly.

CAUTION!

Do not touch halogen bulbs with
your bare hands. If necessary wipe
bulb using a clean cloth dampened
with rubbing alcohol.

Installation is reverse of removal.
Check electrical connector for
corrosion. Spray with contact
cleaner, if necessary.

Foglight application

Front foglight bulb

HB4

630-5

 

 

Turn Signals, Taillights

 

 

Front turn signal assembly,
removing and installing

The procedure below also includes
turn signal bulb replacement.

With engine hood open, use a
screwdriver to press turn signal
assembly retaining clip down to
disengage from retaining tab on
headlight assembly frame.

Screwdriver must reach into fender
hole a minimum of 3 in. to reach the
retaining tab.

 -

Push turn signal forward. Light
slides straight out.

 -

Detach electrical harness
connector.

 -

Twist and remove bulb from rear
of turn signal assembly.

CAUTION!

Do not touch bulb with your bare
hands. If necessary wipe bulb using
a clean cloth dampened with rubbing
alcohol.

Note:

Before reinstalling, make sure rubber
seal on wrap-around trim (underneath
headlights) is firmly glued to trim.
Reglue if necessary.

Front turn signal

Turn signal bulb

12V 21W

 

 

Side turn signal assembly

The yellow marker lights on the sides
of the front fenders are turn signals.
Use plastic prying tool to gently lever
assembly out of fender.

Side turn signal

Side light bulb

12V 5W

 

 

Taillight assembly, removing
and installing

Taillight assembly

1 - Backup light bulb 12V 21W

2 - Rear foglight bulb (Euro only) 12V

21W

3 - Trunk lid/tailgate bulb carrier

4 - Trunk light bulb 12V 10W

5 - Taillight/brake light bulb 12V

21/4W

6 - Turn signal bulb 12V 21W

7 - Brake light bulb 12V 21W

8 - Corner bulb carrier

In E46 cars, taillight functions are split.
The corner bulb carrier on each side
contains:

Taillight bulb

Turn signal bulb

Brake light bulb

Trunk light bulb

The bulb carrier on each side of the
trunk or tailgate contains:

Back-up light

Rear foglight (European models
only)

 -

To access taillight bulbs carriers,
open trunk lid or tailgate.

To access corner bulbs:

Sport Wagon: Remove cargo area
side trim. See 

513 Interior Trim

.

Unlatch bulb carrier retainer
(arrow), then pull carrier off
taillight assembly.

 -

Detach electrical harness
connector.

 -

Replace bulbs as necessary.

CAUTION!

Do not touch bulb with your bare
hands. If necessary wipe bulb using

 

 

 

 

 

 

 

Content   ..  274  275  276  277   ..