Porshe 911 (997). Manual - part 998

 

  Index      Hummer     Porshe 911 997 series - service repair manual 2004-2008 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  996  997  998  999   ..

 

 

Porshe 911 (997). Manual - part 998

 

 

Pericolo di perdita dell'abbinamento testo-immagine nella stampa.

Per motivi tecnici non è escluso che, nonostante la rappresentazione sullo schermo
risulti perfetta, durante la stampa venga persa la corrispondenza fra testo e
relativa immagine.

• 

Se tale difetto non viene rilevato vi è il pericolo che i lavori non siano eseguiti
correttamente; ciò può avere come conseguenza lesioni e danneggiamenti.

• 

→ Per questo motivo, dopo la stampa è assolutamente necessario confrontare le stampe con la
rappresentazione sullo schermo. In caso di errore si prega di correggere le stampe, così da
garantire la riproduzione esatta della rappresentazione sullo schermo.

ADVERTENCIA

Al imprimir se corre el riesgo de perder la correcta asignación de las figuras al texto.

Por motivos técnicos, por el momento no se puede descartar que, aun siendo
correcta la imagen que aparezca en la pantalla, al imprimir se pierda la
correlación entre el texto y la figura correspondiente.

• 

Si este error pasara desapercibido, existe el riesgo de que los trabajos no se
ejecuten de forma correcta y, por tanto, se produzcan daños personales y
materiales.

• 

→ Por ello le rogamos que tras el proceso de impresión compare siempre las copias impresas con
la imagen de la pantalla. En caso de error, corrija las copias impresas de forma que se
correspondan con el contenido de la imagen de la pantalla.

Diagnostic system: reading out fault memory and activating systems

Installing footwell light

4149

- Removing bulb for door warning light
- Installing bulb for door warning light

Removing bulb for door warning light

Removing door warning light

ATTENTION

Danger of damage to property if bulbs are used or handled incorrectly!

Risk of damage to bulbs and bulb housing.

• 

→ Switch off ignition and remove ignition key.

→ To prevent short circuits, the load in question must be switched off while changing bulbs.

→ Only bulbs specified in the bulb table may be used.

→ Bulbs with a higher wattage may damage the bulb housing.

→ New bulbs must be clean and free of grease. Therefore, never touch the bulbs with your bare hands.

Use a cloth or soft paper when changing bulbs.

→ In certain states, it is compulsory to carry spare light bulbs.

Installation Location:

4150

Diagram of door warning light,

F

- Door warning light, left and right

Removing door warning light

1. Push door warning light carefully out of the door trim via the cutaway -arrow- using a screwdriver .

2. Pull off door warning light connector and remove light.

Removing bulb for door warning light

Diagnostic system: reading out fault memory and activating systems

Removing door warning light

4151

Removing bulb for door warning light

1. Remove bulb socket from the door warning light and remove defective bulb.

Installing bulb for door warning light

Installing bulb for door warning light

Note

Only use the relevant bulb specified in the bulb table →  IN IN - Bulb table and installation instructions -
"Information" chapter
.

Diagnostic system: reading out fault memory and activating systems

Removing bulb for door warning light

4152

 

 

 

 

 

 

 

Content   ..  996  997  998  999   ..