|
|
Unplugging electrical connector 2. Unclip electrical connector -a- and unplug. Installing halogen bulb Installing halogen bulb ATTENTION Danger of injury! Danger of material damage if bulbs are used or handled incorrectly! → When installed, the headlight has a high voltage. → Only bulbs specified in the bulb table may be used! → Bulbs with a higher wattage may damage the bulb housing! → To prevent short circuits, the load in question must be switched off when changing bulbs! → New bulbs must be clean and free of grease. Therefore, never touch bulbs with your bare hands! To change the bulbs, use a cloth or soft paper. → Observe the safety instructions when replacing a bulb in a Bi-Xenon headlight. → In certain states, it is compulsory to carry spare light bulbs. Diagnostic system: reading out fault memory and activating systems Installing halogen bulb 4025 |