|
|
disconnected. The vehicle battery may only be re-connected after the re-installation of the belt has been completed. • 1. Install belt tensioner. Observe the direction of travel. 2. Tighten fastening screw -Arrow B- . Tightening torque → Tightening torque: 50 (37 ftlb.) Nm +/-10 % Locking plug for seat-belt tensioner 3. Insert electric connector -2- in the seat-belt tensioner -Arrow . 4. Use a screwdriver or similar tool to push in the fuse in -direction of arrow- until it engages. 5. By gently pulling on the belt -1- , check the winding ability of the belt strap. Installing deflector 6. Position the deflector -2- and the seat belt on the inner side section and tighten with the fastening screws -1- . Tightening torque → Tightening torque: 10 (7.5 ftlb.) Nm Subsequent work Subsequent work 1. Install side trim panel. → 707519 Removing and installing rear side trim panel - chapter on Diagnostic system: reading out fault memory and activating systems Installing three-point belt with seat-belt tensioner 2829 |