Porshe 911 (997). Manual - part 448

Overview, removing and installing door handle

Disconnect connection piece

1. Press locking tabs -Pfeil A- and move sliding part -1- -Pfeil B- .

2. Unclip the connection piece -2- from the actuating shaft -3- .

Removing door lock

Installation Location:

Diagnostic system: reading out fault memory and activating systems

Disconnect connection piece

1949

Main illustration for removing and installing door lock

Removing door lock

1. Undo fastening screws -1- .

2. Pull door lock with actuating motor unit -2- out of the door.

Unclipping and disengaging the bowden cable

Installation Location:

Diagnostic system: reading out fault memory and activating systems

Removing door lock

1950

Main illustration for removing and installing door lock

Unclipping and disengaging the bowden cable

1. Unclip bowden cable from the door lock -arrow A- .

2. Swivel bowden cable by 90° -arrow B- and pull it out of the actuating lever -arrow C- .

Locking lock actuation

Installation Location:

Diagnostic system: reading out fault memory and activating systems

Unclipping and disengaging the bowden cable

1951

Main illustration for removing and installing door lock

Note

To fit the lock actuation correctly, the securing spring must be hooked into the lock actuation lever
before the door lock is installed.

• 

The secured position of the lock actuation is released automatically when the door handle is first
pressed. A clear clicking sound can be heard when the door handle is first pressed.

• 

Note

Pull carefully on the lock actuation to check that it is secured in installation position. Repeat the steps
listed above if necessary.

• 

Diagnostic system: reading out fault memory and activating systems

Locking lock actuation

1952